English Safety Data Sheet Database 中文版 MSDS

6-Methylquinoline

CAS No. 91-62-3 | PubChem CID 7059
Section 1. Identification
Chemical Name6-Methylquinoline CAS No.91-62-3
Synonymsp-toluquinoline; 6-methyl quinoline Chinese Name6-甲基喹啉
Molecular FormulaC10HgN Molecular Weight143.1852
UN No. Data SourcePubChem (NIH/NLM)
GHS Hazard Classification
Signal Word WARNING
Pictograms GHS07 · Irritant
Hazard Statements H302
Precautionary Statements P264P270P301+P317P330P501

Section 2. Hazards Identification

H302 (100%): Harmful if swallowed [Warning Acute toxicity, oral]

P264, P270, P301+P317, P330, and P501 (click each P-code to see the statement)

Aggregated GHS information provided per 1647 reports by companies from 4 notifications to the ECHA C&L Inventory.

Information may vary between notifications depending on impurities, additives, and other factors. The percentage value in parenthesis indicates the notified classification ratio from companies that provide hazard codes. Only hazard codes with percentage values above 10% are shown. For more detailed information, please visit ECHA C&L website.

Section 4. First-Aid Measures

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

Section 5. Fire-Fighting Measures

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

Section 7. Handling and Storage

SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

STORAGE PRECAUTIONS: You should protect this material from exposure to light, and store it in a refrigerator. STORE AWAY FROM SOURCES OF IGNITION. (NTP, 1992)

Section 8. Exposure Controls / Personal Protection

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

Section 9. Physical and Chemical Properties

6-methylquinoline appears as clear pale yellow liquid or oil. (NTP, 1992)

Colourless oily liquid; Pungent heavy quinoline-like odour

497.5 °F at 760 mmHg (NTP, 1992)

259.00 to 261.00 °C. @ 760.00 mm Hg

-8 °F (NTP, 1992)

greater than 235 °F (NTP, 1992)

less than 1 mg/mL at 63 °F (NTP, 1992)

Soluble in benzene and ether; Slightly soluble in water

Soluble (in ethanol)

1.0654 at 68 °F (NTP, 1992) - Denser than water; will sink

1.060-1.066

3 mmHg at 75 °F ; 5.6 mmHg at 111 °F; 10.5 mmHg at 149 °F (NTP, 1992)

1.611-1.617

125.8 Ų [M+H]+ [CCS Type: DT; Buffer gas: N2; Ionization: ESI+; Dataset: TOXCAST; Source Identifier: DTXSID3020887]

125.7 Ų [M+H]+ [CCS Type: DT; Buffer gas: N2; Ionization: APCI+; Dataset: TOXCAST; Source Identifier: DTXSID3020887]

124.3 Ų [M]+ [CCS Type: DT; Buffer gas: N2; Ionization: APCI+; Dataset: TOXCAST; Source Identifier: DTXSID3020887]

Boiling point

Chemical diffusion

Diamagnetic susceptibility

Dielectric constant

Diffusion

Diffusive flux

Heat of sublimation

Magnetic susceptibility

Optical coefficient

Refractive index

Vapor pressure

Viscosity

EU Flavoring substances

FLAVORING AGENT OR ADJUVANT -> FDA Substance added to food

Fragrance Ingredient (6-Methylquinoline) -> IFRA transparency List

Section 10. Stability and Reactivity

Insoluble in water.

Amines, Phosphines, and Pyridines

Hydrocarbons, Aromatic

6-METHYLQUINOLINE is sensitive to prolonged exposure to light. May react vigorously with strong oxidizing agents and strong acids (NTP, 1992). Neutralizes acids in exothermic reactions to form salts plus water. May be incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides. Flammable gaseous hydrogen may be generated in combination with strong reducing agents, such as hydrides.

Source: PubChem CID 7059 (NIH/NLM, public domain). Retrieved from PubChem, a public-domain chemistry database maintained by the U.S. National Library of Medicine. Last updated: 2026-08-02 09:45:16.
Disclaimer: This information is compiled for reference only and does not replace the manufacturer's official Safety Data Sheet. Always consult the supplier's SDS before handling any chemical.